2008 Arctic Cat Prowler / Prowler XT/XTX ATV Service Manual, Page 162Get this manual

2008 Arctic Cat Prowler / Prowler XT/XTX ATV Service Manual, Page 162


NOTE: If the hole in the axle shaft does not align with the slots in the castle nut, tighten the nut until the hole and slots align
To adjust the wheel alignment, use the following procedure1Center the steering wheel; then using an open-end wrench to hold the tie rod ends, loosen the right-side and left-side jam nuts
8Secure the brake caliper to the knuckle with the two cap screwsTighten to 20 ft-lb
PR084A PR377B

Back to 2008 Arctic Cat Prowler / Prowler XT/XTX ATV Service Manual