2008 Arctic Cat Prowler / Prowler XT/XTX ATV Service Manual, Page 147Get this manual
11Remove the snap ring from the ball joint; then remove the ball joint from the A-arm AF610D
3Route the brake hose through the upper A-arm shock absorber mount
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all A-arm components in parts-cleaning solvent2Clean the ball joint mounting hole of all residual Loctite, grease, oil, or dirt for installing purposes3Inspect the A-arm for bends, cracks, and worn bushings4Inspect the ball joint mounting holes for cracks or damage5Inspect the frame mounts for signs of damage, wear, or weldment damageINSTALLING 1Apply green Loctite #609 to the entire outside diameter of the ball joint; then install the ball joint into the A-arm and secure with the circlipAF627D