2008 Arctic Cat Prowler / Prowler XT/XTX ATV Service Manual, Page 114Get this manual
REMOVING 1Remove the seats and center console; then disconnect the three-wire TPS connector plug PR540A
2Remove the screw securing the TPS to the throttle body and remove the TPSINSTALLINGADJUSTING 1Place the TPS into position on the throttle body and secure with the screwDo not tighten at this time2Connect the main harness to the TPS3Locate the diagnostic connector under the seat next to the PDM; then install the test plug from Test PlugError Code List onto the connector4Turn the ignition switch to the ON position and note the position of the TPS indicator icon (A, B, or C); then adjust the TPS until the TPS icon appears in the center position (B)PR541A