2008 Arctic Cat DVX/Utility 50 ATV Service Manual, Page 74Get this manual
SPARK PLUG CAP RESISTANCE
! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter
1Connect the red tester lead to one end of the cap; then connect the black tester lead to the other end of the cap2The meter must read 4725-5775 ohmsNOTE: If the meter does not read as specified, replace the spark plug cap
1Set the meter selector to the OHMS position2Connect the red tester lead to one spade end of the fuse; then connect the black tester lead to the other spade end3The meter must read less than ohm resistanceIf the meter reads open, replace the fuseNOTE: Make sure the fuse is returned to its proper position according to amperage
Ignition Switch
The connector is accessible below the front fender panel in front of the steering postVOLTAGE
NOTE: Perform this test on the harness side of the connector
Ignition Coil
The ignition coil is attached to the upper frame behind the left-side of the front fender panelThe coil can be accessed inside the front-left fender well