2008 Arctic Cat DVX/Utility 50 ATV Service Manual, Page 38Get this manual
(Servicing Components) Piston Assembly 3-16 CylinderCylinder Head 3-17 Centrifugal ClutchDriven Pulley 3-20 Oil Pump 3-21
Table of Contents
NOTE: If the existing rings will not be replaced with new ones, note the location of each ring for proper installationWhen installing new rings, install as complete set only
CLEANINGINSPECTING PISTON RINGS
1Take an old piston ring and snap it into two pieces; then grind the end of the old ring to 45 angle and to sharp edge2Using the sharpened ring as tool, clean carbon from the ring groovesBe sure to position the ring with its tapered side upOnly use parts-cleaning solvent to clean the third ring groove (oil ring groove) of the piston
Piston Assembly
NOTE: Whenever piston, rings, or pin is out of tolerance, it must be replaced
CLEANINGINSPECTING PISTON
! CAUTION