2008 Arctic Cat DVX/Utility 50 ATV Service Manual, Page 17Get this manual
BrakelightTaillight Rotate the ignition switch to the ON position and compress both brake leversThe brakelight should illuminateTo replace the brakelight bulb, use the following procedure1Remove the two screws and remove the lens cover2Remove the bulb by pushing it in and turning it counterclockwise3Install the new bulb by pushing it in and turning it clockwise4Install the lens cover
Electrical Connections
The electrical connections should be checked periodically for proper functionIn case of an electrical failure, check fuse, connections (for tightness, corrosion, damage), andor bulbIf an electrical component needs to be tested for proper function, see Section 5
Brake Systems
! WARNING
After servicing components that are brake-related, ALWAYS check and adjust brakes as necessary before operating the ATV
! CAUTION
Tighten the lens cover screws only until they are snug
Although the brake systems have been adjusted at the factory, the brakes should be checked for proper operationThe brakes must be maintained to be fully functionalCHECKING FRONT WHEEL BRAKE