2008 Arctic Cat DVX 250 / 250 Utility ATV Service Manual, Page 121Get this manual

2008 Arctic Cat DVX 250 / 250 Utility ATV Service Manual, Page 121

NOTE: All bearings, bushings, and seals that are removed must be replaced with new ones INSTALLING 1Install the bearings in the upper arm pivot to depth of 13.6 mm (0.535 in with bearing installer and suitable spacer

5Install the arms to the frame with the pivot cap screws; then tighten the nuts to 32 ft-lb
ATV2196A

2Coat the spacers and the lips of the dust seals with multi-purpose grease; then install them in the upper pivot3Repeat steps and for the lower A-arm4Clean all grease from the ball joint tapers and the knuckle bores; then install the arms to the steering knuckle and tighten the ball joint nuts to 22 ft-lbInstall new cotter pinsKM579

Back to 2008 Arctic Cat DVX 250 / 250 Utility ATV Service Manual