2008 Arctic Cat DVX 250 / 250 Utility ATV Service Manual, Page 71Get this manual
11Connect the front and rear cooling boots to the V-belt housing and secure with the clampsTighten securely12Connect the starter wire to the starter stud and secure with washer and nutTighten securely13Connect the stator connector, shift position connector, and the coolant temperature sensor; then secure the engine ground cable to the engine and tighten the cap screw securely Utility Model
NOTE: Arctic Cat recommends that new gaskets and O-rings be installed whenever servicing the ATV
1Attach suitable engine lift to the front engine mounting boss; then lift the enginetransmission assembly into the frame from the left sideThe front of the enginetransmission should go in firstKM347A KM331
2Lifting the front of the enginetransmission, move the assembly forward sufficiently to clear the rear engine mounts; then engage the secondary bevel driveshaft into the universal joint splines