2008 Arctic Cat ATVs factory service and repair manual, Page 423Get this manual

2008 Arctic Cat ATVs factory service and repair manual, Page 423

INSTALLING 1Position the brake housing on the handlebarSecure with clamp screws; then tighten securely
Throttle Control
REMOVING
1Remove the two machine screws securing the throttle control to the handlebar
2Slide the grommet out of the lower half of the throttle control; then remove the cable from the actuator arm
2Using two new crush washers, connect the banjo-fitting to the master cylinder; then secure with the banjo-fitting boltTighten to 20 ft-lb
3Remove the cap screw, lock washer, and washer securing the actuator arm to the throttle control lever

Back to 2008 Arctic Cat ATVs factory service and repair manual