2008 Arctic Cat ATVs factory service and repair manual, Page 418Get this manual
Seat REMOVINGIINSTALLING
1To remove the seat, lift up on the latch release (located at the rear of the seat)Raise the rear of the seat and slide it rearward
5Secure the front and rear panels with two machine screws; then install the left and right side panelsiNOTE: If the front body panel has not been installed, see Front Body Panellside Panels in this section
2To lock the seat into position, slide the front of the seat into the seat retainers and push down firmly on the rear of seatThe seat should automatically lock into positionREMOVINGIINSTALLING (TRV)
1To remove the rear seat, pull the two latch handles to the rear and rotate them to the vertical position
6Place the seat into position making sure it locks securely
Taillight Assembly
REMOVING
1Unplug the three-prong connector and free the taillight wiring harness from the frame2Remove the tom-head cap screws securing the taillight assembly to the frameAccount for any washers3Remove the taillight assembly