2008 Arctic Cat ATVs factory service and repair manual, Page 407Get this manual
2Install the knuckle to the upper and lower ball ioints and secure with the two caw screwsTighten to 35 ft-lb- 5Install the hub assembly onto the splines of the shaft6Secure the hub assembly with the nutTighten only until snug
3Install the tie rod end and secure with the nutTighten to 30 ft-lb; then install new cotter pin and spread the pinINOTE: During assembling, new cotter pins should be installed
7Secure the brake caliper to the knuckle with the two cap screwsTighten to 20 ft-lb