2008 Arctic Cat ATVs factory service and repair manual, Page 404Get this manual
7Remove two cap screws securing the upper steering post bearing to the frameAccount for two bearings and two housings 10Remove two cap screws securing the lower steering post bearing flange to the frame; then remove the steering post8 Using suitable lift stand, raise the enough to remove the front wheels
CLEANING AND INSPECTING
9Remove the cotter pins and slotted nuts from the inner and outer tie rod ends; then remove the tie rods from the steering post arm and the left-side and right-side steering knuckles=NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary