2008 Arctic Cat ATVs factory service and repair manual, Page 401Get this manual
4Test drive the ATV on dry, level surface and note any pulling to the left or right during acceleration, deceleration, and brakingiNOTE: If pulling is noted, measure the circumference of the front and rear tires on the pulling sideCompare the measurements with the tires on the opposite sideIf pulling is noted during braking only, check and adjust the brakes as necessary and recheck operation (see Section 2) 5Increase the air pressure in the tires with the smallest circumference measurement until all tires are equal in circumference
6Repeat steps 4-5 as necessary to ensure proper handling
Troubleshooting
condition
1Spring(s) weak 2Shock absorber damaged
3Shock absorber preload too low
1Replace spring(s)
2Replace shock absorber 3Adjust shock absorber preload
condition
1A-arm-related bushings worn 2Shock absorber preload too high