2008 Arctic Cat ATVs factory service and repair manual, Page 400Get this manual
11Secure the boot guard to the lower A-arm with the two cap screwsTighten securely 2Remove the wheelsiNOTE: Keep left-side and right-side wheels separated for installing them on their proper sides
12Install the wheel and tighten to 40 ft-lb13Remove the ATV from the support stand
CLEANING AND INSPECTING
=NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
Wheels and Tires
:EY 1Shoulder Screw 2Brake Disc 3Wheel HubFront 4Hub Stud 5Wheel HubRear 6Hex Nut
1Clean the wheels and hubs using pressure washer
2Inspect each wheel for cracks, dents, or bends3Inspect each tire for cuts, wear, missing lugs, and leaksINSTALLING Install each wheel on its hubTighten to 40 ft-lb
11Valve Stem 12Valve Stem Cap