2008 Arctic Cat ATVs factory service and repair manual, Page 397Get this manual
A CLEANING AND INSPECTING
iNOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
3Route the brake hose through the upper A-arm shock absorber mount; then secure the hose to the A-arm with cable tie and grommet
1Clean all A-arm components using pressure washer
2Clean the ball joint mounting hole of all residual Loctite, grease, oil, or dirt for installing purposes3Inspect the A-arm for bends, cracks, and worn bushings4Inspect the ball joint mounting holes for cracks or damage5Inspect the frame mounts for signs of damage, wear, or weldment damageINSTALLING
4Secure the lower eyelet of the shock absorber to the upper A-armTighten nut to 35 ft-lb
5Secure the A-arm assemblies to the frame mounts (from step 2)Tighten the cap screws to 35 ft-lb