2008 Arctic Cat ATVs factory service and repair manual, Page 390Get this manual
w THIS POINT
For servicing the input shaft, pinion gear, needle bearing, and axle seal, see Front Differential in this section
INSTALLING
1Slide the gear case into position through the left side of the frame; then secure it to the frame with cap screws and lock nutsTighten to 45 ft-lb
2Secure the engine output shaft to the rear gear case input flange with four cap screws (coated with red Loctite #271) and lock nutsTighten to 20 ft-lb3Install the rear drive axles (see Drive Axles in this section)4Install the left-side rear A-arms (see Rear A-Arms in Section 7)-
5Remove the hub assembly
6Remove the four cap screws securing the brake disc
CLEANING AND INSPECTING
iNOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
REMOVING
1Secure the ATV on support stand to elevate the wheel; then remove the wheel
1Clean all hub components2Inspect all threads for stripping or damage