2008 Arctic Cat ATVs factory service and repair manual, Page 385Get this manual
11Remove the ATV from the support stand 9Place drain pan under the ATV to contain any oil leakage; then using slide hammer, remove the drive axle
Drive Axles
REMOVING REAR DRIVE AXLE
1Secure the ATV on support stand to elevate the
Make sure the ATV is solidly supported on the support stand to avoid injury
2Pump up the hand brake; then engage the brake lever lock
3Remove the wheel
REMOVING FRONT DRIVE AXLE
INOTE: For removing front drive axle, see Front Differential in this section
4Remove the cotter pin securing the hex nut; then remove the hex nutRelease the brake lever lock
CLEANING AND INSPECTING
iNOTE: Always clean and inspect the drive axle components to determine if any service or replacement is necessary
1Using clean towel, wipe away any oil or grease
from the axle components