2008 Arctic Cat ATVs factory service and repair manual, Page 364Get this manual
OUTPUT VOLTAGE iNOTE: Needle adapters will be required on the multimeter leads as the following tests are made with the sensor connected
1Connect the three-wire plug to the sensor; then remove the right-side mounting screw securing the sensor to the rear frame
INOTE: When replacing the sensor after testing, make sure the arrow marking is directed up
2Install the needle adapters to the multimeter leads; then select DC Voltage on the multimeter
3Connect the red tester lead to the bluelbrown wire (B) and the black tester lead to the blackyellow wire (A); then turn the ignition switch ON and observe the meterThe meter should read 0.8-3.0 DC volts