2008 Arctic Cat ATVs factory service and repair manual, Page 343Get this manual
Electrical System This section has been organized into sub-sections which show procedures for the complete servicing of the Arctic Cat ATV electrical systemINOTE: Some photographs and illustrations used in this section are used for clarity purposes only and are not designed to depict actual conditions
I Ignition Timing Spark Plug Type
Spark Plug Gap Spark Plug Cap Ignition Coil Resistance
1 10' BTDC 1500 RPM NGK CR6E
0.7-0.8 mm (0.028-0.032 in 8000-12,000 ohms (500) 4000 ohms (650(primary) Less than ohm (terminal to ground) (secondary) 5200-7800 ohms (high tension plug cap removedto around)
SPECIAL TOOLS
Ignition Coil (primary1CDI) 140.0-215.0 DC volts500 Peak Voltage 142.4-213.6 DC volts 650 (terminal to ground)
A number of special tools must be available to the technician when performing service procedures in this section
Stator Coil Resistance Peak Voltage
(trigger) (charging) (signal) (trigger) (signal)
160-240 ohms (green to blue) Less than ohm (black to black) Less than ohm (yellow to white' 4.2-6.3 volts (green to blue) 0.4-0.6 volts (yellow to white)