2008 Arctic Cat ATVs factory service and repair manual, Page 340Get this manual
INSTALLING
1Place the fuel pump into position on the electrical tray; then secure with the machine screws and flange nutsTighten securely
2Connect two gas hoses and one vacuum hose; then secure with the clamps
2Remove the two machine screws and flange nuts securing the fuel pump to the electrical tray; then remove the pump
Troubleshooting
(Carbureted Models)
Condition
Starter jet obstructed Starter jet passage obstructed Carburetor leaking air Gas contaminated
Clean jet Clean passage Replace gasket Drain gas tank and fill with clean gas
1 condition
1Slow jet obstructedloose 2Slow jet outlet obstructed
1 Remedy
3Low speed fuel screw setting incorrect
4Float height incorrect 5TPS out of adjustment