2008 Arctic Cat ATVs factory service and repair manual, Page 307Get this manual
12Spread the faces of the driven pulley by pushing the inner face toward the engine while turning it counterclockwise; then when the faces are separated, press the V-belt down between the pulley faces13Place the V-belt into position over the front shaft F1428A
15Rotate the V-belt and driveldriven assemblies until the V-belt is flush with the top of the driven pulley16Install the V-belt housing assembly and tighten the three cap screws securely
INOTE: The arrows on the V-belt should point forward
14Pinch the V-belt together near its center and slide the movable drive face and clutch housing spacer onto the shaftSecure the drive face with cap screw (threads coated with red Loctite #271)Tighten the cap screw to ft-lb
17Place the V-belt cover gasket into position; then install the cover and secure with the cap screws making sure the different-lengthed cap screws are in their proper locationTighten the cap screws to ft-lb