2008 Arctic Cat ATVs factory service and repair manual, Page 306Get this manual
3Install the clutch shoe assembly and secure with the washer (with the flat side facing the assembly as noted in removing) and the nut (threads coated with red Loctite #271)Tighten to 111 ft-lb 7Install the one-way clutch onto the clutch shoe assembly
A CAUTION
When installed correctly, the green dot (or the word OUTSIDE) on the one-way clutch is visible
Care must be taken that the directional washer be installed correctly and note that the nut has left-hand threads
4Lightly grease the clutch housing seal; then insert the primary drive spacer