2008 Arctic Cat ATVs factory service and repair manual, Page 304Get this manual
4Inspect the pins and bushings for wear, flat spots, looseness, or crackingAssembling
4Install the movable face sleeve aligning the hole in the spring seat with the spring anchor hole in the movable face
1Place the fixed face of the driven pulley on the pulley compressor base making sure the dowel pins are engaged in the appropriate holes in the pulley faceWNOTE: Make sure the spacer is on the base or damage to the fixed face will occur when the spring is compressed
5Install the spring over the hub and movable face sleeve; then insert the end of the spring through the sleeve and into the spring anchor hole in the movable face