2008 Arctic Cat ATVs factory service and repair manual, Page 298Get this manual
14Verify that the washers are properly located; then install the magneto cover and secure with the cap screwsTighten only until snug 15Tighten the cap screws (from step 14) to ft-lb16Place the speed sensor housing and new O-ring into position and secure with the cap screwTighten securely17Place the water pump into position and secure with three cap screwsTighten securely
13Install the two alignment pins (A) in the crankcase; then place the gasket in position
18Place the gasket and outer magneto cover into position on the left-side cover; then tighten four cap screws to ft-lbiNOTE: The use of alignment studs (B) will aid in the installation of the magneto cover