2008 Arctic Cat ATVs factory service and repair manual, Page 291Get this manual
Rotate the engine through three or four revolutions; then rotate to top-dead-center (TDC) on the compression stroke and check valve adjustment (see Section 2)With new gasket installed on the cylinder head cover, apply Three Bond Sealant to the camshaft end caps; then place the head cover into position on the cylinder head 23Place new O-ring on the drive end of the starter; then place light coat of grease on the O-ring and install the starterSecure with the two cap screws and tighten securely
Left-Side Components
iNOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment
THIS POINT
To service any one specific component, only limited disassembly of components may be necessaryNote the THIS POINT information in each sub-sectionT iNOTE: The engineltransmission does not have to be removed from the frame for this procedure