2008 Arctic Cat ATVs factory service and repair manual, Page 276Get this manual
21On the left side, disconnect the gear shift position switch (A), stator connector (B), and the crankshaft position sensor connector (C)23Loosen the clamp securing the throttle body to the intake pipe; then remove the throttle body and secure it out of the way 24Remove the two cap screws securing the intake pipe to the cylinder head and remove the intake pipeAccount for an O-ring
A CAUTION
Cover the intake opening to prevent hardware or dirt from entering the intake or severe engine damage could occur
25Remove the engine damper stopper from the frame; then remove the engine damper mount and damper from the engine22Using an absorbent towel to catch any spilled gas,
WNOTE: The engine damper mount is secured the engine with the thermostat housing cap thethescrews.Notethepositionofthebleedvalveinthe e connector; then slide the gasline hose connector thermostat for assembling purposesm