2008 Arctic Cat ATVs factory service and repair manual, Page 269Get this manual
3From the left side7install the three case half mm cap screws (two inside the case); then tighten only until snugWNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6From the right side, install the case half mm cap screws (one inside the case); then tighten only until snugHNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
4From the right side, install the case half mm cap screws; then tighten only until snugHNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
7In crisscrosslcase-to-case pattern, tighten the mm cap screws (from steps 3-4) until the halves are correctly joined; then tighten to 16 ft-1bHNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
8In crisscrosslcase-to-case pattern7 tighten the mm cap screws (from steps 5-6) to ft-lbHNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs