2008 Arctic Cat ATVs factory service and repair manual, Page 255Get this manual
5Remove the three remaining forks noting their positions for assembling purposes 10Remove the crank balancer assembly (A)
=AT THIS POINT
To service gear shift forks, see Servicing Center Crankcase Components sub-section
6Remove the reverse idle gear (K) wlshaftAccount for the bushing, two washers, and the snap ring7Simultaneously, remove the driveshaft assembly (I) and countershaft assembly (D)Account for the washer on the countershaft
=AT THIS POINT
TO service the driveshaft andlor countershaft, See Servicing Center Crankcase Components sub-section.NOTE: his flat spot on the crank balancer to allow clearance the crankshaftpast
=NOTE: For efficiency, if the driveshaft andor countershaft are not being serviced, it is preferable to leave them assembledThe technician should use discretion and sound judgment