2008 Arctic Cat ATVs factory service and repair manual, Page 203Get this manual
6Install the driveshaft iNOTE: If heating the bearing is not possible, the crankshaft can be installed using crankshaft installing tool
7Place washer on each end of the countershaft assembly; then install the assembly
4Install the crank balancer
INOTE: It will be necessary to rotate the crank balancer until the counterweight is facing away from the crankshaft; then rotate the crankshaft clockwise into the journal area to allow the crank balancer to be fully seated
8Place washer on each end of the gear shift shaft; then install the shaft assembly making sure the two holes on the end of the shaft are positioned vertically9Insert the two shift forks into the sliding dogs noting the direction of the tabs from disassembling; then install the shift fork shaftINOTE: Make sure the shift fork tabs face upward and that they are properly seated into the shift cams