2008 Arctic Cat ATVs factory service and repair manual, Page 179Get this manual
8Using Side Case Puller, remove the side coverAccount for gasket and two alignment pinsiNOTE: Inspect the inside of the left-side cover for any shaft washers that may have come off with the coverMake sure they are returned to their respective shafts and that the starter idler gear spacer is on the shaft or in the cover 1 To service the magneto assembly, see Section 5
c AT THIS POINT
11Remove the two starter gears from the crankcase noting the direction of the beveled side of the gears for installing purposes; then remove the two starter gear shafts
9Remove the nut securing the magneto rotor to the crankshaft; then install the magneto rotor puller adapteriNOTE: The puller has left-hand threads