2008 Arctic Cat ATVs factory service and repair manual, Page 150Get this manual
Assembling Crankcase Half INOTE: For ease of assembly, install components on the right-side crankcase halfINOTE: If the output shaft was removed, make sure that the proper shim is installed
3Apply liberal amount of oil to the crankshaft bearingUsing propane torch, heat the bearing until the oil begins to smoke; then slide the crankshaft assembly into place
1Install the output shaft into the crankcase making sure the two gears, shim, washer, and nut are in the correct order
INOTE: If heating the bearing is not possible, the crankshaft can be installed using crankshaft installer