2008 Arctic Cat ATVs factory service and repair manual, Page 146Get this manual
6Noting the position of the two holes on the end, remove the shift cam assemblyAccount for inner and outer washers
CAUTION
Do not remove the remaining output shaft assembly unless absolutely necessaryIf the shaft is removed, the shaft nut must be replaced with new one and1 the shaft must be re-shimmed
10Remove the secondary drive gearlsecondary driven gear retaining nutFrom inside the crankcase using rubber mallet, drive out the output shaft assemblyAccount for the output shaft, shim, washer, and the nut
u AT THIS POINT
To service crankshaft assembly, see Servicing Center Crankcase Components sub-section
7Remove the counterbalance gearAccount for the key8Remove the counterbalance shaft
Servicing Center Crankcase Components