2008 Arctic Cat ATVs factory service and repair manual, Page 140Get this manual
6Place the spring holder on the spring engaging the spring end with the appropriate anchor hole 9Continue compressing the spring while guiding the spring holder onto the hubWhen slight resistance is felt, stop turning the wing nut
10Install the nut (threads coated with red Loctite #27l); then tighten the nut to 74 ft-lb using the spanner and torque wrench
7Assemble the notched-ring nut, spring holding handle7one flat washer, and the wing nut in order on the pulley compressor bolt; then thread the wing nut onto the boltI IRemove the wing nut, washer7and holding handle; then remove the driven pulley from the pulley compressor