2008 Arctic Cat ATVs factory service and repair manual, Page 132Get this manual
11Tighten the cap screws (from step 9) in crisscross pattern securely 12Place the gasket, recoil starter assembly, and cover into position on the left-side cover making sure the single washer is properly positioned; then install and tighten the four cap screws to ft-lb
Right-Side Components
w THIS POINT
To service center crankcase components only, proceed to Removing Right-Side Components
UNOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment
w AT THIS POINT
To service any one specific component, only limited disassembly of components may be necessaryNote the THIS POINT information in each sub-sectionT
2Mark the movable drive face and the fixed drive face for installing purposes; then remove the nut holding the movable drive face onto the crankshafi