2008 Arctic Cat ATVs factory service and repair manual, Page 131Get this manual
4Install the shift detent cam making sure the spacer is properly positioned 8Place the key into its notch; then slide the rotor1 flywheel (with the ring gear in place) over the crankshaftTighten the nut to 116 ft-lb
CCover DRecoil Starter
HNOTE: Steps 1-8 in the preceding sub-section must precede this procedure
9Install two alignment pins and place the left-side cover gasket into positionInstall the left-side coverNoting the different-lengthed mm cap screws, the position of the shifter bracket, and the location of the long cap screw with the washer, tighten cap screws only until snugMD1086