2008 Arctic Cat ATVs factory service and repair manual, Page 88Get this manual
1Remove the output shaft assembly (J) 2Remove the two shift shafts (E and H)
INOTE: Note the alignment marks on the crank balancer driven gear and balancer drive gear (C) to aid in assembly
3Remove the reverse shift cam (G) and spacer
4Disengage four forks from the gear shift cam (F); then remove the reverse shifter fork
9Remove the driven gear from the crank balancer assembly (A)Account for key
5Remove the gear shift cam (F)
INOTE: Note that the shoulder of the gear is directed to the outside for assembling purposes
6Remove the three remaining forks noting their positions for assembling purposes
10Remove the crank balancer assembly (A)
INOTE: When removing the crank balancer assembly, rotate the crankshaft counterweight away from the crank balancer assembly counterweight