2008 Arctic Cat ATVs factory service and repair manual, Page 75Get this manual
15Install the mm cap screws and mm cap screw to secure the left-side coverOnly finger-tighten at this time 16Place the gear shift stopper wlspring and washer into position above the hillow shift shaft making sure the spring and stopper are correctly positionedTighten to 16 ft-lb
13Install the two alignment pins into the left crankcase halfiNOTE: Make sure that three washers and two alignment pins are in place
17Place the speed sensor into position and secure with the two cap screwsTighten securely
Make sure the speedometer gear and output shaft gear match up during assembly