2008 Arctic Cat ATVs factory service and repair manual, Page 67Get this manual
=NOTE: To aid in installing, it is recommended that the assemblies are kept together and IN ORDER 4Remove the cap screws securing the left-side cover to the crankcase; then using an appropriate slide hammer and adapter, remove the left-side cover
ADriven Gear Drive Gears #I#2 CIdler Gear DShift Fork with Pin EShift Shaft
FStarter Idler Gear #I GStarter Idler Gear #2 HStarter Clutch Gear Assembly RotorIFlywheel
5Remove the nut securing the rotorlflywheel (I) to the crankshaft; then install the crankshaft protector
6Using the Magneto Rotor Remover, remove the rotorlflywheel assembly from the crankshaftAccount for the key; then remove the starter clutch gear assembly (H) wlwasheriNOTE: Care must be taken that the remover is threaded all the way onto the rotorlflywheel