2008 Arctic Cat ATVs factory service and repair manual, Page 48Get this manual
iNOTE: Use cable ties or tape to secure the carburetor assembly above the handlebar to keep it from interfering with the removal procedure 19Disconnect the following electrical components: voltage regulator, CDI, indicator lights, and the two wire leads for the oil temperature sensors
16Remove the clamps securing the two oil cooler hoses to the engine; then disconnect the hoses
iNOTE: After disconnecting the oil cooler hoses, plug them to prevent leakage from the cooler
17Disconnect the high tension lead from the spark plugAt the ignition coil, remove the cap screw, nut, and the two wire leads; then remove the coil18Disconnect the battery ground (negative) cable from the crankcase cover; then disconnect the positive cable from the starter motor20Loosen the clamp on the crankcase breather vent hose; then disconnect the hose and remove it