2008 Arctic Cat ATVs factory service and repair manual, Page 29Get this manual
HNOTE: During the bleeding procedure, watch the reservoir sight glass very closely to make sure there is always sufficient amount of brake fluidWhen the sight glass changes from dark to light, refill the reservoir before the bleeding procedure is continuedFailure to maintain sufficient amount of fluid in the reservoir will result in air in the system =NOTE: The brake pads should be replaced as a
4To replace the brake pads7use the following procedureARemove the wheelBRemove the cap screws securing the caliper holder to the knuckle; then remove the pads
DRepeat step until the brake lever is firmEAt this point7perform step B7 C7and on the other FRONT bleeder screw; then move to the REAR bleeder screw and follow the same procedure4Carehlly check the entire hydraulic brake system that all hose connections are tight, the bleed screws are tight7 the protective caps are installed7 and no leakage is present
fhis hydraulic brake system is designed to use DOT brake fluid onlyIf brake fluid must be added, care must be taken as brake fluid is very corrosive to painted surfaces