2008 Arctic Cat ATVs factory service and repair manual, Page 27Get this manual
Manual Transmission
3Tighten the jam nuts securely; then shift the transmission to each position and verify correct adjustment
4Install the left-side engine cover and seat making sure the seat locks securely in place5Loosen the front shift rod jam nut (1) (left-hand threads); then loosen the rear shift rod jam nut (2) (right-hand threads)
Stop the ATV completely and shift the transmission into the positionThe reverse gear indicator light should be illuminated
Never shift the ATV into reverse gear when the ATV is moving as it could cause the ATV to stop suddenly throwing the operator from the ATV
If the reverse light does not illuminate when shifted to the reverse position, the switch may be faulty, the fuse may be blown, the bulb may be faulty, connection may be loose or corroded, or the lever may need adjustingTo adjust, proceed to Adjusting Shift LeverADJUSTING SHIFT LEVER 1Remove the seat; then remove the left-side engine coverINOTE: Steps 2-4 are for all models except the 700 EFIFor the 700 EFI, proceed to step 5