2008 Arctic Cat ATVs factory service and repair manual, Page 17Get this manual
ValveTappet Clearance (700 EFI)
To check and adjust valveltappet clearance, use the following procedure=NOTE: The seat, heat shields, splash panels, front rack, and front fenders must be removed for this procedure (see Section 8)
2Rotate the crankshaft to the TDC position on the compression strokeINOTE: At this point, the rocker arms and adjuster screws must not have pressure on themiNOTE: Use Valve Clearance Adjuster for this procedure
1Remove the spark plug caphigh tension lead; then using compressed air, blow any debris from around the spark plug
Always wear safety glasses when using compressed air
3Place the valve adjuster onto the jam nut securing the tappet adjuster screw; then rotate the valve adjuster dial clockwise until the end is seated in the tappet adjuster screw