2008 Arctic Cat 700 Diesel ATV Service Manual, Page 178Get this manual
INSTALLING 1Place the return spring into the throttle control; then place the bushing and actuator arm into positionSecure with the cap screw, lock washer, and washer 2Remove two cap screws, two self-tapping screws, and three nylon ties securing the left-side splash panel and remove the panel3Remove the axle and nut securing the shift lever to the upper shift arm; then remove the shift leverAccount for spring and two O-rings4Using two open-end wrenches, remove the lock nut securing the shift rod to the upper shift armRemove the shift rod and discard the lock nutNOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut
INSTALLING 1Place the shift rod into position on the engine shift arm and secure with the existing E-clipAF679D
2Using pair of needle-nose pliers, place the spring into position on the actuator arm
2Using new lock nut (B), secure the shift rod to the upper shift arm; then using two open-end wrenches, tighten securely