2008 Arctic Cat 700 Diesel ATV Service Manual, Page 177Get this manual
INSTALLING 1Position the brake housing on the handlebarSecure with clamp screws; then tighten securely Throttle Control
REMOVING 1Remove the two machine screws securing the throttle control to the handlebar2Slide the grommet out of the lower half of the throttle control; then remove the cable from the actuator arm
2Using two new crush washers, connect the banjo-fitting to the master cylinder; then secure with the banjo-fitting boltTighten to 20 ft-lb
3Remove the cap screw, lock washer, and washer securing the actuator arm to the throttle control lever