2008 Arctic Cat 700 Diesel ATV Service Manual, Page 172Get this manual
Taillight Assembly REMOVING 1Unplug the three-prong connector and free the taillight wiring harness from the frame2Remove the torx-head cap screws securing the taillight assembly to the frameAccount for any washersCD690A
3Install one shoulder screw and three plastic rivets (on each side) to secure the front of the rear body panel to the footwells
3Remove the taillight assemblyINSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Inspect wiring harness, three-prong connector, lens, base, cap screws, and socket for damage2Inspect all wires for corroding, pinching, and cracking3Inspect the bulb for wattage, voltage, and proper operationCD691
INSTALLING 1Place the assembly into position on the frame and secure with torx-head cap screws and any washers2Tighten the cap screws securely3Route the wiring harness over the rear frame; then connect the three-prong connector