2008 Arctic Cat 700 Diesel ATV Service Manual, Page 156Get this manual
7Install the tie rod end and secure with the nutTighten to 30 ft-lb; then install new cotter pin and spread the pin to secure the nutNOTE: During assembly, new cotter pins should be installed CD008
13Install the wheel and tighten to 45 ft-lb14Remove the ATV from the support stand
Rear A-Arms
REMOVING 1Secure the ATV on support stand to elevate the wheels
8Apply grease to the hub and drive axle splines; then install the hub assembly onto the drive axle
! WARNING