2008 Arctic Cat 700 Diesel ATV Service Manual, Page 139Get this manual
10Apply liberal amount of grease to the O-ring; then install it on the assembled cover assembly making sure to seat the O-ring down around the circumference of the bearing flange11Making sure the O-ring is properly positioned on the gear case cover assembly, install the cover with existing hardwareAccount for the ID tagTighten the cap screws to 23 ft-lbNOTE: Grease can be applied to the O-ring for ease of assemblingNOTE: If new gear case housing is being installed, tighten the cap screws to 25-31 ft-lb
2Using propane torch, heat the area surrounding the needle bearing to soften the Loctite