2008 Arctic Cat 700 Diesel ATV Service Manual, Page 125Get this manual
2Connect the red tester lead to one wire; then connect the black tester lead to the other wire3With the dimmer switch in the LO position, test the two outside connectors (LO beam)The meter must show battery voltage4With the dimmer switch in the HI position, test the two inside connectors (HI beam)The meter must show battery voltageNOTE: If battery voltage is not shown in any test, inspect the fuses, battery, main wiring harness, connectors, or the left handlebar switch 2Connect the red tester lead to the redblue wire; then connect the black tester lead to the black wire3With either brake applied, the meter must show battery voltageNOTE: If the meter shows no voltage, inspect bulb, fuses, wiring harness, connectors, and switches
Fuel Solenoid
The fuel solenoid is used in conjunction with the ignition switch to control fuel flow from the lift pump to the unit injectorsThis enables the operator to shut off the engine quickly using the emergency stop switch or the ignition switchTo test the fuel solenoid, use the following procedure1On suitable multimeter, place the switch in the DC Volts position; then connect the black tester lead to suitable ground and the red tester lead to the fuel solenoid terminal