2008 Arctic Cat 700 Diesel ATV Service Manual, Page 120Get this manual
RESISTANCE (HI Beam) 1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; then connect the black tester lead to the gray wire3With the dimmer switch in the HI position, the meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness 3With the switch in the OFF position, the meter must show an open circuit4With the switch in the RUN position, the meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness
RESISTANCE (LO Beam) 1Connect the red tester lead to the white wire; then connect the black tester lead to the gray wire2With the dimmer switch in the LO position, the meter must show an open circuitNOTE: If the meter reads resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness
Front Drive Selector Switch