2008 Arctic Cat 700 Diesel ATV Service Manual, Page 67Get this manual
3Holding tension on the belt, tighten the adjuster cap screw securely; then remove the pry and tighten the pivot bolt securely4Connect the battery (B+) wire and connect the regulator control plug-in; then connect the negative battery cable to the battery5Install the-left side engine cover and seat making sure the seat latches securely Right-Side Components
NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment
4Remove the PTOflywheel; then remove four countersunk cap screws securing the V-belt housing to the engine block and remove the V-belt housing
AT THIS POINT
To service any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in each sub-section